CAUTION Halogen lamps contain gas under pressure. Special precautions are required when handling and dismantling halogen lamps. Protect your eyes. Avoid rubbing or scratching the surface of the lamp. Avoid spilling liquid on a burning lamp without a socket. Switch on the lamp only after it has been installed. Replace faulty lamps. When replacing a halogen lamp, do not touch the glass parts of the lamp with unprotected hands. Keep out of reach of children. Dispose of lamps with extreme caution. Lamps are explosive.
Headlights
Replacing the lamp
1. Open the hood.
2. Remove the retaining plugs holding the upper radiator cap.
3. Remove the upper radiator cap.
4. Remove 3 bolts and the entire headlight assembly.
5. Remove the headlight cover.
6. Disconnect the spring that holds the lamp.
7. Remove the lamp.
8. Install a good lamp of the correct type.
9. Install the spring on the new lamp.
10. Install the headlight cover.
11. Connect the wire plug.
If you need to clean halogen lamps, use a lint-free cloth soaked in alcohol or alcohol-containing mineral cleaners. Do not touch the lamp with bare hands. Fingerprints can significantly reduce the life of halogen lamps.Parking lights
2. Remove the entire headlight assembly.
3. Remove the headlight cover.
4. Remove the bulb holder located next to the high beam headlight bulb.
5. Remove the bulb by pulling it straight out of the socket.
6. Install the new lamp.
7. Install the headlight cover (in reverse order).Front direction indicator lamps
3. Disconnect the wire plug from the lamp socket.
4. Rotate the turn signal bulb socket counterclockwise.
5. Remove the front turn signal bulb socket from the headlight.
6. Remove the bulb from the socket by pressing it lightly and turning it counterclockwise.
7. Install the new bulb into the socket by pressing it lightly and turning it clockwise.
8. Install the socket into the headlight by turning it clockwise.
9. Install the headlight assembly.Front fog lights
Lamp replacement is carried out at a service station.Reversing light, parking lights, brake light, rear direction indicator and rear fog light
1. Open the back door.
2. Unscrew the two screws and remove the headlight unit.
3. Unscrew the lamp holder by turning it counterclockwise.
4. Remove the bulb from the socket by pressing it and turning it counterclockwise.
5. Install the new lamp into the socket.
6. Install the socket into the headlight unit. Rotate the bulb socket clockwise.
7. Place the headlight assembly back and screw in the 2 screws removed earlier.
8. Close the back door.Additional brake lightLicense plate lighting
1. Unscrew the two screws and remove the lamp cover.
2. To remove the socket from the flashlight, rotate it clockwise.
3. Remove the lamp from the socket.
4. Replace the lamp.
5. Install the socket into the flashlight by turning it clockwise.
6. Install the lantern cover.Upper lampshade/individual lighting lantern
1. Use a slotted screwdriver to remove the lampshade from the interior of the vehicle.
2. Remove the lamp.
3. Replace the lamp.
4. Install the ceiling in place.Ceiling light on the front door
1. Use a flat-head screwdriver to remove the lampshade from the interior of the vehicle.